How To Make Table Legs Out Of 4x4
-c3x41 Channel Top Plate.
How to make table legs out of 4x4. Mark the jig with the leg blanks position. Handcrafted from concrete wood and steel this dining room table measuring 90 in length x 42 wide x 30 tall was created by combining hickory wood and natural gray concrete. Table top is old top so no video on table top build.
Set Kreg Jig to 1-12 material. Leave the saw fence at this setting. Remove the blank and glue or screw positioning cleats on the long edge and at the end towards you.
Apply a liberal amount of glue to the face of one of the 24 pieces. With your 1 paddle back drill bit drill a ½ deep hole around 6 in from each end on the bottom on the leg and the ends of the table. Insert 5 lag bolts into these holes.
The concrete and wood top is supported by a welded steel frame finished with a semi-gloss black powder coat. -Natural Steel Rust As Shown Once item is purchased please leave a note as to what finish you would like. Each leg helps disperse the weight and can also reinforce the base.
Video is of a bottom of a farm table build and tools i used. Position your table leg blank on the jig with the portion to be removed hanging off the edge cut by the band saw. Drill 1-12 pocket holes two per end on the 2x3 and 2x4s.
Begin by cutting your 2x4s to length. Price is for set of 2 Material. The legs are built out of nothing more than simple 4x4s that you can buy at any home improvement store and should take no longer than an hour to construct.
