How To Make A Wood Turning Tool Sharpening Jig

Straight or Curved Edge Sharpener Tormek SVS-50.

How to make a wood turning tool sharpening jig. Turn the parting tool over and do the opposite side for the same amount of time. Now I glue a piece of plywood to the bottom. I cut the notches by tilting my table saw wheel to 45 degrees and cranking it down as low as it would go.

Pivot the tool back and forth over the moving wheel To use the jig for a bowl gouge with drawn back wings. If you do it yourself allow some extra length for the 30mm square and angle due to the cutting blade thickness. Tormek SVS-38 Short Tool Jig - Sharpen Short Woodworking Tools like Short Wood Chisels Carving Gouges Tools for Power Carvers etc.

Turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel for a few seconds. The Multi-Jig For Sharpening Skew Chisels Gouges Beading Tools and More. Using the raptor set up tool set the wolverine jig arm to the appropriate angle.

Moreover it comes with an easy setup. First I cut all the hard plywood pieces with the table saw and make an adjustment groove with the router table in several runs. Set Wolverine Jig Arm.

Insert the tool in a 45 degree holder. Ad Find Deals on Products in Power Tools on Amazon. Ensure that the raptor tool touches the wheel at two points and is resting firmly in the wolverine jig.

Adjust the jigs leg per the manufacturers instructions set it in the V-rest and then slide the rest out so that the center of the bevel rests on the center of the wheel. Place the studding nut and washer to tighten the grip. The end result should be the point of the parting tool be ground to a sharp squared of point.