How To Clean Bare Wood After Sanding
The most effective way to clean wood after sanding is to brush all the dust off the wooden surface using a painters dust brush and then wipe the surface with a lint-free rag and mineral spirits.
How to clean bare wood after sanding. Clean unfinished wood with a damp rag before staining. If you plan on using a water-based stain use Minwax Water Based Pre-Stain Wood Conditioner. Spritz With Distilled White Vinegar For a small amount of mold growth that has not left severe stains or penetrated the wood distilled white vinegar can kill the spores.
Wipe down the whole surface with a tack cloth to remove any dust from sanding. Once soaked you want to use a stiff bristle brush to scrub the surface of the deck being sure to keep it wet. Using a soft-bristle attachment thoroughly vacuum the floor baseboards and windowsills.
Once youre done sanding make sure youve gotten rid of ALL the sanding dust before you do anything else. The hand brush will get rid of rough pieces and bits. There are approved methods you can use to clean the dust before applying a polyurethane sealant or staining the surface.
Wipe the surface thoroughly with a a wet cloth. To remove those last bits of finish palm sand with medium sandpaper 150 grit until you see the bare wood. Before doing anything else with your woodwork rub a tack cloth over the entire surface of the wood to remove the dust and residue.
The mineral spirits will clean any grime or grease off of your surface making it ready for painting or staining. Whether youve just installed a wood floor or added some fresh trim to your windows or doorways or even built a craft or furniture piece from scratch you may find yourself in a situation where the unfinished wood needs cleaning but you want to use something that wont affect. Removing dust from baseboards and windowsills will prevent accidental showers of sanding dust getting knocked onto the floor while youre coating it with finish.
Mix the cleaner according to the instructions on the bottle and allow it to soak into the wood for 15 minutes. When exposed it will absorb water or the cleaner and warp. When using oil-based conditioner allow it to penetrate into the wood for 5-15 minutes.
