How To Use Metal Stud Framing

A guide on how to set-up and use the Sealey 3-in-1 Metal Voltage and Stud DetectorProducts used in this video buy online today3-in-1 Metal Voltage Stu.

How to use metal stud framing. Place a mark of metalworking glue through the metal plate posts on one side of the box press a plate panel on the front side and then add it with screws. Headers are built up from multiple steel. After all most homes use wood studs not metal.

Cut the sides of the track or stud first bend backwards and cut through the web. For a typical steel stud wall youll need track for. Three threads or 38 of the screw should be visible on the back side of the connection.

To do this youll need to leave that last stud loose until the drywall goes up. To cut the track and stud use aviation snips. The information included in this post is for informational purposes only and should not be taken as legal financial or DIY advice.

Other drill bits can result in a jagged hole. Fastening the Metal Studs and Finishing Up 1 To trim to correct length cut both side flanges of a steel stud. Steel framing is usually spaced at 4 OC.

You can use specialized metal stud framing screws. If youre using a drill bit twist bits tipped with carbide titanium or cobalt provide the best results. Metal stud sizes arent common knowledge.

C section studs replace wood studs and single tracks replace top and bottom wood plates. The proper way to drywall an inside corner with metal stud framing is to slide the first sheet all the way into the inside corner and then fasten the last stud on the wall adjacent to the drywall. Use straight-cut aviation snips for this.