How To Use A Table Saw Step By Step

Always try to hold the workpiece with a firm grip to withstand the cutting pressure of the saw.

How to use a table saw step by step. However the saw is handheld which basically means that it doesnt come along with a surface or a table. Slide the rip fence for the inner edge to match the desired width of the cut. Prepare the table saw for cutting Once youve adjusted the fence and blade height lower the blade guard over the blade to protect you from debris.

Adjust the height of the saw blade. Dont cut the material without the table support. You can use the ruler that comes with your fence to find the accurate position of the fence.

There is an old saying in construction and woodworking. Deciding on Angled Cuts. That is why you need out-feed support or a table to help in holding the board as it leaves the table saw.

Now that weve gotten the safety features discussed and handled lets move into the instructions for using a table saw. Keep it flat against the table saw blade. If you want to make a cross cut by the table saw then line the mark up by eye on the wood or you may mark on your board by pencil.

Set the rip fence so that it touched wood at the right distance from the blade. Set the blade depth 14-inch below the material you are cutting. A ripping cut requires that you adjust the blade such that its higher than the thickness of the wood.

Wood Placement Place the wood on the table against the saw. Release the locking lever on the front of the fence to position the rip fence. Setting the Height of the Blade.