How To Turn Spindles On A Wood Lathe

Widen the groove to prevent the tool from grabbing.

How to turn spindles on a wood lathe. They then split that section of the trunk into usable sized billets in a process called riving A froe the edged tool with the wooden handle at right is used to rive wood. To make the blank round mount it on the lathe between the headstock and tailstock and use the roughing gouge to reduce it to a cylinder. Once the rest of the spindle is turned simply move the steady a bit 6 is usually enough and turn the oversizeburned spot to size.

Conclusion You can often limp through turning one long spindle using a skew and the hand wrapped around the work trick. Turn on the lathe and gently probe the chisel into one end of the spindle blank. Nov 7 2018 - Explore Ray Browns board Spindle followed by 293 people on Pinterest.

Start at one end and remove the corners Photo 10a. Check your work by stopping the lathe to see if the spindle blank is round or by running the lathe and resting the back of the chisel on the blank. The tenons were cut by mounting the blanks in the Spigot Jaws of the chuck and running the lathe at a very slow speed.

The roughing gouge is a very versatile gouge but it must be used. You should cut above center for most lathe tools. If the finished spindle will retain a square segment youll need to first turn a pommel the transition from square to round.

Prepare a spindle of appropriate length. When the grain of the turning blank is at right angles to the lathe then you are doing faceplate or bowl turning. Turn out the middle with a small gouge leaving a flat-bottomed recess ¼ deep.

Install the aluminum fingers onto the ends of the wood blocks securing them in place with the 1 10-40 bolts and lock nuts. They would fell a tree of suitable wood then buck sections of the bole the trunk between the roots and the first branches into lengths suitable for the spindles they intended to turn. If you switch from a thick tool like a spindle roughing gouge to a thinner tool like a skew you will need to raise the tool rest.