How To Sharpen A Wood Lathe Parting Tool

A demonstration on how to sharpen a lathe parting tool.

How to sharpen a wood lathe parting tool. This lets you know youre making appropriate contact. Simply turn the wheel on and draw the tool across the surface of the stone. How to Sharpen Wood Turning Tools.

For a few seconds turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel. Turn the parting tool over and do the opposite side for the same amount of time. The end result should be the point of the parting tool be ground to a sharp squared of point.

The same amount of time turn the parting tool over and do the opposite side. Learn how to sharpen a parting tool on your bench grinderShop sharpening supplies. Make sure you clamp up the handles nice and tight wipe off any excess epoxy that oozes out from the handles being squeezed together.

At length the result must be the point of the parting tool to be ground to a sharp squared point. Keep on going this way until you are satisfied with the sharpening of your lathe tools. To sharpen adjust the flat tool rest so that the tools bevel angle matches the wheel.

Now put little pressure to scrape tool back and forth over the stone. Next fasten your tool into the varigrind jig. The tool should protrude 2 from the jig and your varigrind should be set at a 23º angle.

You can get 30 minute epoxyyep just click on that link or check out your local big box store. As you sharpen and make contact move your wood lathe tool gently from side to side to get the entire edge. How to Sharpen Wood Turning Tools - YouTube.