How To Sharpen A Lathe Parting Tool

It wobbles a bit much and tends to round the cutting edge.

How to sharpen a lathe parting tool. To sharpen you need to hold the stone in one hand and place your lathe tool at a 45-degree angle. When you sharpen a lathe tool bit youre really re-drawing a number of critical angles. Shaping skew chisels are pretty easy to do as well.

A demonstration on how to sharpen a lathe parting tool. Turn the parting tool over and do the opposite side for the same amount of time. A hone is quite effective because of the small surface area involved.

The end result should be the point of the parting tool be ground to a sharp squared of point. Unless the cutting edge is in really bad shape you may not need anything more than a hone to do the job. Ad Easy to Use - Laser Fits in Spindle 4-Axis 00002 resolutn Fast Setup.

While applying a little pressure scrape your tool back and forth on this sanding stone. Turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel for a few seconds. For a few seconds turn the grinder on and lower the tip of the parting tool onto the moving grinding wheel.

To sharpen adjust the flat tool rest so that the tools bevel angle matches the wheel. At length the result must be the point of the parting tool to be ground to a sharp. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy Safety How YouTube works Test new.

Attach the dial indicator to a Noga holder found in the metrology cabinet and place gently on the guideways DO NOT slide the holder along the. Ad Easy to Use - Laser Fits in Spindle 4-Axis 00002 resolutn Fast Setup. How to Sharpen a Parting Tool.