How To Prepare Wood For Painting After Sanding

Start with 60-grit sandpaper and then do final smoothing with 100-grit sandpaper.

How to prepare wood for painting after sanding. You will need a hand brush to clean the dust. Pour the mineral spirits over the stripped area and use the steel wool to wipe away any remaining stripper residue be sure to follow the wood grain. The first thing first is surface cleaning.

It takes four steps to sand wood to perfection. This video is part 2 in a series about making over an AOM bamboo dresser. Once you are done with that bring in tack cloth to give proper finishing to the cleaning procedure.

Before painting wood siding fill large holes and gouges with a two-part resin filler such as Minwax High Performance Wood Filler. Once the surface is cleaned up get ready to perform the initial sanding. Heat and friction when both applied to the material can smoothen the surface immediately.

Mount 7-inch sanding discs onto it for sanding the primary surfaces and then switch to 5-inch sanding pads for places where you need tighter control. Wipe With Denatured Alcohol Many woodworkers end the wood preparation step with the tack-cloth wipe-down but for the very best results conclude your preparation by wiping down the surfaces with a clean cloth moistened with denatured alcohol. You have to mix these setting types of fillers but they stick better to wood than other fillers.

You will need to use mineral spirits after sanding. A coarser sandpaper is perfect for the job. Also the advantage of using mineral spirits when compared to water is that water swells wood also.

These are the same steps as cleaning before painting. Tear sandpaper sheets into fourths then fold them into pieces just big enough to hold with three fingers. How to Sand Wood Siding Use a power a 5-inch power disc sander to smooth the edges of scraped areas or remove paintit is lightweight and easy to handle.