How To Prep Wood After Sanding

The primer also keeps any stains on the wood from coming through the paint.

How to prep wood after sanding. Using fine-grit wet and dry sandpaper to remove dust that stuck on the last coat. Or if you want to recycle and re-stain an old piece. If you still have paint or varnish remaining on your wooden project you can repeat the stripping process and again use mineral spirits and steel wool to.

Since Water Based Pre-Stain Wood Conditioner causes the wood fibers to swell you will need to lightly sand the surface with a fine grade sandpaper 15-30 minutes after. There are many different wood conditioners available on the market. Once youre done sanding make sure youve gotten rid of ALL the sanding dust before you do anything else.

Work efficiently by starting with a coarse sandpaper in the 60-100 grit range and gradually switch to finer sandpapers rated closer to 150 grit. While you can use any cloth to do this a tack cloth will pick. It takes four steps to sand wood to perfection.

If you plan on using an oil-based stain you must use the oil-based Minwax Pre-Stain Wood Conditioner. Use a good vacuum and then a tack rag to wipe the surface clean of any contaminants. While blowing the dust off with compressed air removes the dust it also mixes it into the air so some of it can settle back onto the surface and so you can breath it.

Choosing a pre-stain wood conditioner is simple. For smaller wood items like furniture wash the wood. After you have cleaned the wood with a damp rag following the sanding process it is time to prep the wood for stain.

Wipe the surface thoroughly with a a wet cloth. It is a great tool for cleaning a large portion. It is good to use a shop vac to clean the surface between sanding grits removing the larger grit particles from the wood before sanding with the next higher grit.